Crankshaft hardening machine
In the method hardness of the crank pin surface is measured and when the hardness is over a predetermined limit value, depth of the hard spot is measured. Heat treatment parameters are determined at least on the basis of the depth measurement and the hard spot is heat treated. During the heat treatment the hard spot is heated by an induction heating device.
350 kW / 5-30 kHz (bearings, 2x) 100 kW / 5-30 kHz (flange + shaft end, 1x)
Production rate: 30 sec/pc
Part size: up to 1500 mm
Fillet hardening Loading/unloading: automatic via conveyor Automatic part indexing
350 kW / 5-30 kHz (bearing, 1x)
50 kW / 5-30 kHz (flange + shaft end, 1x)
50 sec/pc
up to 800 mm
manual, robot, gantry
350 kW / 5-30 kHz (bearings, 2x)
100 kW / 5-30 kHz (flange + shaft end, 1x)
Production rate: 30 sec/pc
Part size: up to 1500 mm
Optional fillet hardening
Loading/unloading: automatic via conveyor
Automatic part indexing
Kunden von SAET EMMEDI profitieren von den Ressourcen eines weltweiten Konzerns. Unser Netzwerk aus regionalen Vertriebs- und Serviceingenieuren bietet Unterstützung in aller Welt.
